Grass Valley UIM v.2.1.1 - Manual (Page 115)

February 5, 2008 UIM Instruction Manual 115
If you have a problem: UIM-DIS-GEIP
Step 8: FTP a file using the 1000BT interface
connected to the streaming LAN
Use the following steps test the UIMs ability to stream a file over the 1000BT
streaming interface. This test does not actually transfer the file over the 1000BT
network, but can be looked at as a 1000BT loop-back test. You’ll first get, then put a
Profile media file. Be sure to choose a small file to shorten the test time.
1. On the UIM, open a command prompt window, then use the following syntax to
ftp a media file. Insert your own host names and file names. Text you enter is in
bold.
C:\TEMP>ftp XP1_he0
Connected to XP1_he0.
220 UIM FTP Server (2, 0, 9, 1) ready.
User (XP1_he0:(none)): movie
230 Aspect successfully set to MOVIE.
ftp> bin
200 Type set to IMAGE.
ftp> get /explodedFile/EXT:/default/clipname clipname_he0.gxf
200 PORT command okay.
150 Opening MOVIE mode data connection for /explodedFile/EXT:/
default/clipname.
250 Transfer complete.
ftp: xxxxxxx bytes received in x.xxSeconds xxxx.xxKbytes/sec.
ftp> put clipname_he0.gxf /explodedFile/EXT:/default/
clipname_back_he0
200 PORT command okay.
150 Opening MOVIE mode data connection for /explodedFile/EXT:/
default/#1_back_he0.
250 Transfer complete.
ftp: xxxxxxx bytes sent in x.xxSeconds xxxx.xxKbytes/sec.
ftp> bye
221 Goodbye.
2. Perform one of the following steps:
• If the test passes, all required software and hardware components in the UIM are
functional. If the problem persists, verify external cabling and switch
equipment.
• If the test fails, contact Grass Valley Product Support. See “Before calling
product support” on page 111 .