Gasboy 1000 Series Technical Reference Manual - Manual (Page 95)

FleetKey Systems
03/07/03 4-3
If your system uses the Auto Pin Lockout feature, the key is automatically
locked out (invalidated) after the third unsuccessful PIN entry.
6. If you are required to enter an odometer (or hours) reading, the LCD
displays: ENTER ODOMETER or ENTER HOURS.
Use the keypad to enter the mileage/time that appears on your vehicle’s
odometer or hour meter (up to seven digits, no tenths). The digits appear as
they are entered. If you make a mistake, press CLEAR and enter the
reading again. When you enter the correct reading, press ENTER. The
system performs a reasonability check and if the reading is accepted, it
writes the value to the key (into the last odometer field). For more on
reasonable odometer check, see the FleetKey Operation Manual.
7.
If your system has the Maintenance option, you may receive a message
indicating that maintenance is DUE SOON, DUE NOW, or OVERDUE. For
more on the Maintenance option, see the FleetKey Operation Manual.
8. If your system requires a manual entry field, the prompt for that field
appears. Type the data requested and press ENTER. At this time, your
odometer is written to your key and the LCD displays: PLEASE WAIT.
When your key has been updated, the LCD displays: SELECT PUMP.
NOTE: Do not remove the key during the PLEASE WAIT message.
Removing the key early can cause key failure. If a read error is
encountered on the next use, you must re-encode the key before it
can be used again.
9.
Enter the desired pump number and press ENTER.
If the pump you selected cannot be accessed, one of the following
messages appears:
NO SUCH PUMP
PUMP IN USE!
PUMP DISABLED
INVALID FUEL
You have three tries to select a correct pump. If after three attempts, you
have not chosen a correct pump, the display changes to TURN KEY
LEFT,REMOVE, and you must turn and remove your key and start again at
Step 2.
If the pump is available and you are authorized to use it, your odometer will
be written to your key at this time and the display will show PLEASE WAIT.
When your key has been updated, the LCD displays TURN KEY
LEFT,REMOVE.
10. Remove the key(s) from the receptacle(s). If you leave the key(s) in the
receptacles for more than five seconds, an alarm sounds to remind you to
remove them.