Gasboy 1000 Series Technical Reference Manual - Manual (Page 37)

Card Systems
03/07/03 2-19
Product Authorization
Standard The product authorization feature controls access to fuel type(s). Using the LF
command, the system operator can load up to nine authorization codes (1-9) with
up to nine fuel types per code. The user is permitted to access only the fuel
type(s) loaded into the system for the authorization code encoded on his card.
The authorization code 0 permits access to all fuels. Figure 2-8 shows a product
authorization code table initiated by the PF command.
RBÂ
7WVDÂÂ9Q@A0ÂÂ!ÂÂ7HHQYUÂBWAHU !ÂÂ "ÂÂ #ÂÂ $ÂÂ %Â
7WVDÂÂ9Q@A0ÂÂ"ÂÂ7HHQYUÂBWAHU !Â
7WVDÂÂ9Q@A0ÂÂ#ÂÂ7HHQYUÂBWAHU "Â
7WVDÂÂ9Q@A0ÂÂ$ÂÂ7HHQYUÂBWAHU #Â
7WVDÂÂ9Q@A0ÂÂ%ÂÂ7HHQYUÂBWAHU $Â
7WVDÂÂ9Q@A0ÂÂ&ÂÂ7HHQYUÂBWAHU %Â
7WVDÂÂ9Q@A0ÂÂ'ÂÂ7HHQYUÂBWAHU "ÂÂ #Â
7WVDÂÂ9Q@A0ÂÂ(ÂÂ7HHQYUÂBWAHU #ÂÂ $ÂÂ %Â
7WVDÂÂ9Q@A0ÂÂ)ÂÂ7HHQYUÂBWAHU $ÂÂ %ÂÂ
Â
Figure 2-8. Product Authorization Codes
CFN Network The fuel authorization table for Commercial Fueling Networks is limited to 500
authorization codes and fuel types. For example, you can have 100 codes with 5
fuel types each, or 50 codes with 10 fuel types each, etc. The system operator
uses the LF command to load authorization codes which can be numbered from
01-99. Code 00 is preset to allow all fuel types.
"A" System For "A" Systems, the product authorization codes can be one or two digits and
can be located anywhere on the card. The table values should be the same or
similar to those loaded on the "A" System. For more on authorization codes for
"A" System cards, see Card Layout and Field Descriptions earlier in this
section.
Product Limitation
Description The product limitation feature controls the amount of product that can be
dispensed in one transaction. The limit is specified by the limitation code encoded
on the card. Using the LL command, the system operator can load the 10
available limitation codes (0-9) with any quantity from 1 to 99999. If a user
reaches the maximum limit that has been entered for the code on his card, then
the pump is automatically turned off causing a LIMIT CUTOFF error message.
Figure 2-9 shows a product limitation code table initiated by the PL command.