Gasboy 1000 Series Technical Reference Manual - Manual (Page 118)

GASBOY Series 1000
4-26 03/07/03
Pump Switch Timer
Description The Pump Switch Timer option allows you to prevent fueling at a pump when the
handle has been left on from a previous transaction.
In a normal transaction when you request a pump, the pump is activated, the user
turns on the pump handle and fueling begins. Occasionally, the pump handle
may have been left on from a previous transaction. When a new transaction is
initiated, the pump cannot reset and, if pumping is allowed, the quantity shown at
the pump includes the previous transaction quantity.
With the pump switch timer option, the handle is checked at the beginning of each
transaction. If it is found to be on, a TURN OFF PUMP HANDLE message
appears and the transaction is terminated. A transaction is generated with the
message PMP SW ERROR. The user must turn off the pump handle and begin a
new transaction in order to fuel.
Receipt Printer
Description The Receipt Printer option allows the user to obtain a transaction receipt for fuel
dispensed through the Series 1000. Receipts are available only for those
transactions where fuel is dispensed; error and other no quantity transactions
cannot be printed. An additional option allows for up to three receipts to be
generated for a transaction. The number of receipts is set using the SC
command.
Sequence Obtaining a receipt is accomplished as follows: After a user fuels his vehicle in
the normal fashion and wants a receipt, he goes back to the Series 1000 and
inserts his key (or keys). The system asks if he wants a receipt. If the reply is
yes, a receipt is printed and the transaction is finished.
If he does not choose to get a receipt, the next time he attempts to fuel, the
system checks through the last 16 transactions with quantity. If one of these
matches his key data, the system asks if he wants a receipt (for that transaction).
If the reply is yes, the system prints a receipt. He must then insert his key(s)
again to begin the fueling transaction. If the reply is no, the system proceeds with
a normal fueling operation.
Transaction receipts are not available if:
•
There are no available receipt transactions in the system memory for the
key.
•
The receipt printer is in an error condition. (i.e., printer jammed, paper out,
printer down).
The system operator can issue a receipt printer command, GR, from the data
terminal to obtain a receipt for a specific transaction number.