Gasboy 1000 Series Technical Reference Manual - Manual (Page 117)

FleetKey Systems
03/07/03 4-25
Miles Per Gallon History Option
Description The MPG History option allows the Series 1000 FleetKey system to calculate and
maintain a cumulative miles-per-gallon tally for keyholders based on one of the ID
fields that is specified at the time of order (this field is usually a vehicle number,
VEH). The exact number of users supported depends upon the limit specified
when the system was ordered.
MPG File
Information
MPG software computes fuel efficiency averaged over a period of time
determined by the system operator (usually a month). Standard transaction MPG
provides MPG per transaction. To use the MPG history option, the system
operator enters information on each of the users into an MPG file record. Each
MPG record contains four fields and a status flag:
● REC 1- to 20-digit number from a field you specify at time of
order.
● B ODOM up to 7-digit beginning odometer reading
● E ODOM up to 7-digit ending odometer reading (last recorded)
● GALLONS up to 8-digits for total gallons for period
● STAT a record status code indicating MPG comments (for more on
status flags, see the VF command)
Printing options The system operator can print out the MPG file (Figure 4-16) to view the record
number, beginning and most recent odometer entries, the total number of miles,
the total number of gallons, the miles per gallon calculation, and the record status.
XBÂ
Â
TA9ÂÂ8ÂQ@QIÂÂAÂQ@QIÂÂIEHAUÂÂÂÂÂC7HHQPUÂÂIRCÂ Â UV7VÂ
%$#Â #!"%&Â #!%%$Â ")(ÂÂÂÂ!& ÂÂ!(&Â
!#$"Â $#%'(Â $#)%'Â #')ÂÂÂÂÂ'! ÂÂ%#$ÂDECDÂ
!(!! !")&' !")() ""ÂÂÂÂ!!& ÂÂÂ!)ÂHQYÂ
"(!& #% !$ $"&%! '&#'ÂÂÂ$'$#% ÂÂÂ!&!Â
#"$$Â "$&$$Â "$&$$Â ÂÂÂÂÂ ÂÂÂ ÂÈÈÂ
$" Â ! Â "% Â !% ÂÂÂÂ"(! ÂÂÂ%#Â22Â
%!)&Â Â "'#%Â "'#%ÂÂÂÂÂ ÂÂÂ ÂÂ
Â
Figure 4-16. MPG File Printout
Multi-Level Password
Description The Multi-Level Password option provides two levels of passwords: super user
and standard user. The super user password allows you to access all system
commands including the CP command. The CP command allows you to
selectively authorize or restrict commands that the standard user is allowed to
access. When you use diagnostic test 1 to initialize the password, both
passwords are set to GASBOY.
Change
Password
To change the super user password, sign on as GASBOY and use the LS
command to change the password. Use the EX (exit) command to exit command
mode and sign on again as GASBOY. You are now in standard user mode. To
change the standard user password, sign on as GASBOY and use the LS
command to change the password.