Gasboy 1000 Series Technical Reference Manual - Manual (Page 114)

GASBOY Series 1000
4-22 03/07/03
Fuel Point
Description The FleetKey system can be purchased with a Fuel Point option. The hardware
required for the Fuel Point option can be factory-installed on a new system, or
retrofitted to an existing system. Refer to the following Fuel Point manuals for
information on system installation and retrofitting:
•
Fuel Point Reader Installation, C35628
•
Fuel Point Hose and Dispenser Retrofit Installation, C35593
•
Vehicle Module Installation, C35699
•
Vehicle Module Programming Manual, C35629
•
Fuel Point Parts, C35709
There are two variations on the Fuel Point option: the standard Fuel Point option
or the Fuel Point Gate option. The standard option allows you to authorize up to
8 fueling positions. The gate option allows you to designate a fueling position
(hose) as a gate controller The gate option requires a special vehicle module with
gate antenna connectors on the vehicle and installation of a special ground loop
antenna buried in the driveway.
Special
Considerations
When you have the Fuel Point option, several FleetKey commands have
additional prompts or operate differently. Refer to the FleetKey Operation
Manual, Appendix D for a complete description of these changes.
Gate Controller
Description The Gate Controller option enables you to control access to a gate using a
dedicated Series 1000.
Sequence When the user inserts his key, the gate controller verifies the key and activates
the gate relay.
Transaction
Matching
If you have an existing FleetKey, the Gate Controller system can be configured to
match your existing transactions.
Memory Full The Gate Controller can also be ordered with Memory Full protection disabled.
This means when the system memory is full, new transactions will overwrite the
transactions already in memory. When you select this option, you cannot retrieve
transactions, the only record will be the direct printout copy.
Hours
Description An Hours option is available for user equipment that is monitored with an hour
meter instead of an odometer. When you select the hours option, ENTER
HOURS is displayed on the LCD in place of ENTER ODOMETER. The prompt
MPG? 1=YES, 0=NO is replaced with HPG? 1=YES, 0=NO. If yes is selected,
HPG is shown.