Accessories, Crt terminal and printer, Diagnostic kits – Gasboy 1000 Series Technical Reference Manual User Manual
Page 153

03/07/03
8-1
Section 8
ACCESSORIES
CRT TERMINAL AND PRINTER
Use and Setup
A CRT terminal and printer setup is used for updating and retrieving information
from the Series 1000 system.
Cables and connectors are not included with the terminal and must be ordered
separately. (See Section 6, Communications). The Series 1000 supports the
following CRT and printer:
CRT Terminal
●
LINK MC5 Terminal (GASBOY P/N C03813
)
Interface Modes: EIA RS-232 C Main and Auxiliary Ports, IBM-compatible
Centronics 25-pin interface, 50-38.4K Baud
Power: 110/220 VAC, 50/60 HZ
Dimensions: (HxWxD) 12.5" x 13.3" x 12.2"
Weight: Terminal: 20 lbs, Keyboard: 3 lbs.
Keyboard: Low profile, Extended PC (EPC) layout
Display: 14" diagonal, 24, 25 or 43 scrollable lines, 80 or 132 columns, two
hosts simultaneously windowed on screen, 10 X 16 character cell (60 HZ),
10 X 13 character cell (78 HZ)
Data Transmission: Asynchronous, Full Duplex, Half duplex, local, block or
monitor
Additional Features: Includes CRT-Printer adapter DB9F-DB25F
Printer
●
Okidata 184 Serial Printer (GASBOY P/N C03814
)
Interface modes: RS-232C
Power: 120 VAC, 220/240 VAC
Dimensions: (HxWxD) 3.2" x 14.2" x 10.8" Weight: 9.9 lbs.
Print speed: 155 cps, utility; 186 cps @10 and 17.1 cpi; 232 cps @ 12 cpi,
draft; 40 cps, NLQ.
Data Transmission: Asynchronous full duplex
DIAGNOSTIC KITS
Description
Diagnostic kits are available to aid in troubleshooting the system. The kits are
available with an LCD meter (P/N C05759) or less the meter (P/N C05757). The
kits include:
Plastic Screwdriver
Pump Simulator/Keypad Tester
Diagnostic Manual
RS-422/RS-232 Loop Back Connectors
AC Adapter Cable
Mag Reader Test Cable
Direct Communication Cable
Autoranging Digital Multimeter (Optional)