Gasboy 1000 Series Technical Reference Manual - Manual (Page 112)

GASBOY Series 1000
4-20 03/07/03
OPTIONAL SYSTEM FEATURES
Activate Pump Data Entry
Description This option allows you to enter key data and an odometer reading at the data
terminal before activating a pump. The system prompts you for the key numbers,
ID fields, and odometer before allowing you to select a pump. When this
transaction is recorded, the digits of information, which are usually read from the
key, are replaced by those entered at the data terminal. If you do not need to
enter data for a particular field, press RETURN at that field; it will be filled with
nines (9).
Auxiliary Communications Port PCB
Description An optional auxiliary port PCB may be available if you have ordered the receipt
printer or tank monitor options. This board contains two ports (one for a receipt
printer and one for a tank monitoring system), configurable to either RS-232 or
RS-422. Each has a selectable baud rate of 300, 1200, or 9600. The receipt
printer is always set to 9600. Most tank monitoring systems should be set to 300
or 1200 and, for optimum data transfer, should run at the same baud rate as the
data terminal.
Encoding Option
Description
The Encoding option allows you to use the FleetKey system to encode your data keys. You can
encode keys two ways: using diagnostic mode, which is convenient when
encoding many keys; or using a special encoding key, for occasional encoding.
If you do not choose the Encoding option, you can have your keys encoded by
GASBOY or purchase a GASBOY KE200 Key Encoder/Maintenance Terminal
(C06292) and encode your own.
Extended Pump Timeouts
Description The Extended Pump Timeouts option allows the before and after pulsing
timeouts, loaded through the LP command, to be longer than 180 seconds. The
timeouts can be extended to 3600 seconds (one hour).
Fuel Allocation
Description The Fuel Allocation option allows the system operator to allocate to users, over a
period of time, predetermined amounts of fuel. This option works effectively only
in a single site operation.
Requirements At the time of order, the system operator must indicate the key field to be
assigned the allocation totalizers and the number of totalizers. This field must be
a numeric field (Key or one of the ID fields). It cannot be a manual entry field.