Gasboy 1000 Series Technical Reference Manual - Manual (Page 94)

GASBOY Series 1000
4-2 03/07/03
FUELING PROCEDURE
Overview Using the Series 1000 System is easy, even for untrained users. Operating
instructions are printed on the face of the cabinet and, when a key (or keys) is
entered, a series of prompts appear on the LCD display to guide the user through
the fueling transaction. The following steps outline a typical fueling using a Series
1000 FleetKey system.
Procedure 1. Position your vehicle adjacent to the fuel dispensing equipment. Be sure to
note the odometer reading (if your system requires you to enter it).
In its idle state, the FleetKey LCD display alternates between an INSERT
KEY message and a personalized system message.
2. The system may have one or two key receptacles and you may be required
to use one or two keys.
If you have only one key, insert it into a key receptacle and turn it clockwise.
The LCD displays PLEASE WAIT.
If you have two keys and two receptacles, insert both keys and turn them
both clockwise together or separately. The LCD displays PLEASE WAIT.
If you have two keys and only one key receptacle, insert either key. The
LCD displays PLEASE WAIT. A customized message appears prompting
you to insert your other key. Remove the first key and insert and turn the
second key. The LCD displays PLEASE WAIT.
3.
If you have the receipt printer option or the transaction MPG/HPG feature
enabled AND a prior transaction is present where a receipt or MPG/HPG
reading was not obtained, the system may prompt you for a receipt or
MPG/HPG. If you respond 0=NO, the fueling process continues. If you
respond 1=YES, the system presents your receipt or displays MPG and then
goes to idle. You must re-insert your keys to begin a new fueling
transaction.
4.
If your key requires PIN entry, proceed with Step 5. If your key requires
odometer entry only, skip to Step 6. If your key requires neither, skip to Step
7.
5.
If you are required to enter a Personal Identification Number (PIN), the LCD
displays: ENTER PIN.
Using the keypad, enter your PIN number and press ENTER. To ensure
security, an asterisk (
* ) appears for each digit that you press. If you make a
mistake while entering your PIN, press CLEAR and enter it again.
You have three tries to enter the correct PIN. After the third unsuccessful
try, the display changes to REMOVE KEY, and you must turn and remove
your key and start again at Step 2.