Gasboy 1000 Series Technical Reference Manual - Manual (Page 68)

GASBOY Series 1000
3-2 03/07/03
FUELING PROCEDURE
Overview Using the GASBOY Series 1000 system is easy, even for untrained users.
Operating instructions are printed on the face of the cabinet and, when a vehicle
number is entered, a series of prompts appears on the LCD display to guide the
user through the fueling transaction. The following steps outline a typical fueling
using a Series 1000 Cardless system.
Procedure 1. Position your vehicle adjacent to the fuel dispensing equipment. Be sure to
note the odometer reading (if your system uses this feature).
In its idle state, the Series 1000 LCD display alternates between an ENTER
VEHICLE message and a personalized system message.
2. Using the keypad, enter your vehicle number and press ENTER. If you make
a mistake while entering your vehicle number, press CLEAR and enter it
again.
If the vehicle number entered is valid the system proceeds to the next step,
otherwise an error message displays on the LCD and the system returns to its
idle state.
If your system uses the receipt printer option, go to Step 3, otherwise go to
Step 4.
3. If you have the receipt printer option and a transaction receipt is available, the
LCD displays: RECEIPT? 1=YES 0=NO.
To print a transaction receipt, press 1 and ENTER. The LCD displays:
RECEIPT IS PRINTING. If you have requested multiple receipts, they print
out one after the other. The system goes to idle and you must re-enter your
vehicle number to begin a fueling transaction.
If you do not want a receipt, press 0 and ENTER. Skip to Step 4. For more
on receipt printing, see the Cardless Operation Manual.
4. If you are required to enter an odometer reading, the LCD displays: ENTER
ODOMETER
Use the keypad to enter the mileage that appears on your vehicle’s odometer
(up to six digits, no tenths). The digits appear as they are entered. If you
make a mistake, press CLEAR and enter the odometer reading again. When
you enter the correct odometer reading, press ENTER.
5. If you are required to enter a second account field, such as an employee
number, the LCD displays: ENTER EMP.
Use the keypad to enter the employee number. The digits appear as they are
entered. If you make a mistake, press CLEAR and enter the employee
number again. When you have entered the correct number press ENTER.