Gasboy 1000 Series Technical Reference Manual - Manual (Page 86)

GASBOY Series 1000
3-20 03/07/03
Reasonable Odometer/Hours Check Only
Description The Reasonable Odometer/Hours option provides an odometer or hours validity
check for a set number of your vehicles (*NOTE: Hours-per-gallon is used when
user equipment is monitored with an hour meter instead of an odometer). The
exact number of vehicles supported is chosen at the time of order. When
specifying the number of vehicles, the user should consider any plans for
expansion of the vehicle fleet in the future. The Reasonable Odometer/Hours
option is similar to the MPG/HPG option without the MPG/HPG features.
Vehicle File The Reasonable Odometer/Hours option adds these fields to those already
present in the vehicle file:
•
ODOM/HOURS up to 6-digit odometer/hours entry
•
STAT a special code indicating reasonable odometer/hours
comments
Enable/Disable In the vehicle file, you can selectively decide whether to enable or disable
reasonable odometer/hours for each vehicle. When the system detects an
odometer/hours entry, the vehicle record is checked to see if reasonable
odometer/hours check is enabled.
Sequence If reasonable odometer/hours is enabled, the odometer entry is checked against
the last odometer reading entered. The system also considers the maximum
miles between fuelings value (LM command). If the odometer/hours entry is out
of range, the system prompts for another entry. If reasonable odometer/hours
check is disabled for a vehicle record, the odometer/hours entry is recorded in the
vehicle file but not checked for validity. See the Cardless Operation Manual for a
description of reasonable odometer/hours processing.
Figure 3-18 shows a vehicle file printout with the reasonable odometer option.
XBÂ
Â
XADÂÂ HEIÂ 7WVDÂ 9@Â HQ9GÂ ÂQ@QIÂ UV7VÂ
!"Â Â#Â Â%Â Â"Â ÂÂPÂ Â #!"% Â
!( Â" Â! Â$ ÂÂP  $#%'(ÂÈÈÂ
%$ Â% Â' Â! ÂÂa  !")&'Â
Â
Â
Figure 3-18. Reasonable Odometer Vehicle File
Receipt Printer
Description The Receipt Printer option allows the user to obtain a transaction receipt for fuel
dispensed through the Series 1000. Receipts are available only for those
transactions where fuel is dispensed; error and other no quantity transactions
cannot be printed. An additional option allows for up to three receipts to be
generated for a transaction. The number of receipts is set using the SC
command.