Delta Electronics AC Servo Drive ASDA-B - Manual (Page 95)

Chapter 5 Trial Run and Tuning Procedure|ASDA-B Series
5-2 Revision February 2008, Doc. Name: 2006PDD23000009
Item Content
Inspection during
operation
(Control power is
applied)）
z Ensure that the cables are not damaged, stressed excessively or loaded heavily.
When the motor is running, pay close attention on the connection of the cables
and notice that if they are damaged, frayed or over extended.
z Check for abnormal vibrations and sounds during operation. If the servo motor is
vibrating or there are unusual noises while the motor is running, please contact
the dealer or manufacturer for assistance.
z Ensure that all user-defined parameters are set correctly. Since the
characteristics of various machinery are different, in order to avoid accident or
cause damage, do not adjust the parameter abnormally and ensure the
parameter setting is not an excessive value.
z Ensure to reset some parameters when the servo drive is off (Please refer to
Chapter 7). Otherwise, it may result in malfunction.
z If there is no contact sound or there be any unusual noises when the relay of the
servo drive is operating, please contact your distributor for assistance or contact
with Delta.
z Check for abnormal conditions of the power indicators and LED display. If there is
any abnormal condition of the power indicators and LED display, please contact
your distributor for assistance or contact with Delta.