Comtech EF Data RCS20 - Manual (Page 93)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–59
4.3.3.8 SWITCH MINOR ALARMS 2
These screens display minor alarms.
CAUTION
Masking alarms may cause undesirable modem performance
Key Label Function
S1  Press to move the blinking cursor up through the list of faults.
S2  Press to move the blinking cursor down through the list of faults.
S3 TOG MODE Used to toggle between YES (masked) and NO (not masked).
S4 NEXT Press to cycle to the next screen.
Numeric Keypad ---
Press or to abort programming (no switch parameters changed).
Press to load the information on the screen into the switch parameter table.
4.3.4 TEST Menu Tree
4.3.4.1 SWITCH SYSTEM TESTS
This screen allows execution of the following tests:
SWITCH MINOR ALARMS
MASK
COMMUNICATIONS : PASS NO
PRIME MODEM STATUS : FAIL NO
BACKUP MODEM STATUS : PASS NO
PRIME MODEM CONFIGURATION : FAIL NO
  TOG MODE NEXT
NEXT
SWITCH SYSTEM TESTS
SYSTEM COMMUNICATION TEST
MODEM PARAMETER COMPATIBILITY TEST
LAMP TEST
COMM PARM LAMP NEXT