Comtech EF Data RCS20 - Manual (Page 78)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–44
4.3.2.16.1 Programming steps:
1. Use the numeric keypad to enter the desired backlight timeout value in seconds. Valid values are
0 to 255 seconds.
2. Press or to abort programming (no switch parameters changed).
3. Press to load the information on the screen into the switch parameter table. Switching will
occur immediately after pressing .
Key Label Function
S1 --- N/A
S2 --- N/A
S3 --- N/A
S4 NEXT Press to cycle to the next screen.
Numeric Keypad ---
A value (in seconds) from 0 to 255 is entered.
Press to disregard the value entered on the keypad, keep the previous value, and
cycle back to the LCD CONTRAST ADJUSTMENT Screen.
Press to select the value entered on the keypad and cycle to the next screen.
4.3.2.17 BANK CONTROL CONFIGURATION
This screen displays disabling of IFS and DDS and combining IFL. To modify parameters, press S1, S2 or
S3.
Key Label Function
S1 IFS Press to cycle to the IFS BANK CONTROLLER Screen.
S2 DDS Press to cycle to the DDS BANK CONTROLLER Screen.
S3 IDL Press to cycle to the COMBINE IFL Screen.
S4 NEXT Press to cycle to the next screen.
Numeric Keypad --- N/A
BANK CONTROL CONFIGURATION
DISABLE IFS: NO
DISABLE DDS: NO
COMBINE IFL: NO
IFS DDS IDL NEXT