Comtech EF Data RCS20 - Manual (Page 173)

RCS20 M:N Redundancy Switch Revision 15
Remote Operations MN-RCS20 and CD-RCS20
A–31
<1> *Channel 0 Backup1
IFS20L Demod Port
Assignment 0 = A, 1 = B, 2 = C, 3 = D
<1> *Channel 0 Backup2
IFS20L Demod Port
Assignment 0 = E, 1 = F, 2 = G, 3 = H
<2> *Spares for Channel 0 Spare Bytes
These 6 bytes will repeat for channels 1 through 9 (54 additional bytes used).
A.3.9 Opcode <2204h> Set RCS20 Backup Mode
Command Data Field (3 bytes)
<1> Maximum Number of
Backup Channels 2 for RCS20
<1> Backup 1 (Channel 0)
Backup Mode 0 = Manual, 1 = Automatic non-Revertive, 2 = Automatic Revertive
<1> Backup 2 (Channel 9)
Backup Mode 0 = Manual, 1 = Automatic non-Revertive, 2 = Automatic Revertive
(will be ignored if Channel 9 is not configured as backup)
A.3.10 Opcode <2205h> Clear RCS20 Latched Alarms
There is no data field for this command.
A.3.11 Opcode <2206h> Force RCS20 Manual Backup
Command Data Field (3 bytes)
<1> Maximum Number of
Backup Channels 2 for RCS20
<1> Backup 1 (Channel 0)
Channel to Backup 1 to 8 (if Channel 9 configured as backup) (use 0 to un-back)
1 to 9 (if Channel 9 not configured as backup) (use 0 to un-back)
Bits 0-3 = Modulator
Bits 4-7 = Demodulator
<1> Backup 2 (Channel 9)
Channel to Backup (1 to 8) (use 0 to un-back)
Bits 0-3 = Modulator