Comtech EF Data RCS20 - Manual (Page 58)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–24
4.3.1.18 COPY MODEM CONFIGURATION
This screen allows the user to copy configurations between (from/to) modems.
Key Label Function
S1 CURSOR Press to toggle between COPY FROM and COPY TO.
S2 UP
Press to cycle up through the modems in the line selected by
pressing S1 (MODEM1 - MODEM9).
S3 DOWN
Press to cycle down through the modems in the line selected by
pressing S1 (MODEM9 - MODEM1).
S4 CANCEL Press to cycle back to the LEARN/BACKUP TEST
CONFIGURATION Screen.
Numeric Keypad ---
Press to accept the selection from S1, S2, and S3.
Press to abort changes and cycle back to the
LEARN/BACKUP TEST CONFIGURATION Screen.
4.3.1.19 MOD FAULT DELAY
This screen allows the user to program the modulator fault delays (in seconds) for each prime channel on
the RCS20. The fault delays for a modulator are used to debounce the modulator faults, thus if a
modulator fails, a timer is started and the failure will not be recognized by the RCS20 until the timer
COPY MODEM CONFIGURATION
to accept, to abort.
COPY FROM : MODEM1
COPY TO : MODEM8
CURSOR UP DOWN CANCEL
MOD FAULT DELAY (SECONDS) USE KEYPAD
MOD :MOD1 MOD2 MOD3 MOD4 Mod5
0.5 0.5 0.5 1.0 0.5
MOD6 MOD7 MOD8 MOD9
0.5 0.5 0.5 0.5
<--- ---> NEXT