Comtech EF Data RCS20 - Manual (Page 70)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–36
4.3.2.7 REMOTE PORT ADDRESS
This subscreen allows the user to modify the RCS20 remote port baud address.
4.3.2.7.1 Programming steps:
1. Use the numeric keypad to enter the desired multi-drop address for the RCS20. Valid addresses
are 32 through 255.
2. Press or to abort programming (no switch parameters changed).
3. Press to load the information on the screen into the switch parameter table. Switching will
occur immediately after pressing .
Key Label Function
S1 --- N/A
S2 --- N/A
S3 --- N/A
S4 RETURN
Press to select the value entered on the keypad and cycle back to the TERMINAL
PORT CONFIGURATION Screen
Numeric Keypad ---
Use the numeric keypad to enter the desired multi-drop address for the RCS20. Valid
addresses are 32 through 255.
Press or to abort programming (no switch parameters changed).
Press to load the information on the screen into the switch parameter table.
Switching will occur immediately after pressing .
REMOTE PORT ADDRESS : 32
RETURN