Comtech EF Data RCS20 - Manual (Page 85)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–51
4.3.2.26 RDM FALLBACK CONFIGURATION
This screen allows the user to configure the RDM Internal Reference Frequency. The internal frequencies
may be one of the following:
• MHz
• MHz
• MHz
• 10.0 MHz
4.3.2.26.1 Programming steps:
1. Press to change the displayed internal frequency.
2. Continue pressing until the desired frequency is displayed.
3. Press or to abort programming (no switch parameters changed).
4. Press to load the information on the screen into the switch parameter table.
Key Label Function
S1
TOG
MODE
Press to cycle through the above listed internal frequencies.
S2 --- N/A
S3 --- N/A
S4 RETURN
Press to cycle back to the REFERENCE DISTRIBUTION CONFIGURATION
Screen.
Numeric Keypad ---
Press or to abort programming (no switch parameters
changed).
Press to load the information on the screen into the switch parameter table.
RDM INTERNAL REFERENCE CONFIGURATION
INTERNAL FREQ : 10.0 MHZ
TOG MODE RETURN