Comtech EF Data RCS20 - Manual (Page 66)

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–32
Key Label Function
S3 --- N/A
S4 NEXT Press to cycle to the next screen.
Numeric Keypad --- N/A
4.3.2.3 TERMINAL PORT BAUD RATE
This subscreen allows the user to modify the RCS20 terminal port baud rate.
4.3.2.3.1 Programming steps:
1. Press <19200>, <9600>, or <2400> to select the desired terminal port baud rate. The switch
parameter table will be updated immediately.
2. Press or to abort programming.
IMPORTANT
After changing the Terminal Port Baud Rate, power must be cycled before the baud
rate change takes effect.
Key Label Function
S1 19200 Press to select 19200 bps.
S2 9600 Press to select 9600 bps.
S3 2400 Press to select 2400 bps.
S4 CANCEL Press to cycle back to the TERMINAL PORT CONFIGURATION Screen
Numeric Keypad --- Press or to abort programming (no switch parameters changed).
TERMINAL PORT BAUD RATE
BAUD RATE: 19200
19200 9600 2400 CANCEL