Comtech EF Data RCS20 - Manual (Page 172)

RCS20 M:N Redundancy Switch Revision 15
Remote Operations MN-RCS20 and CD-RCS20
A–30
<1> Backup 2 (Channel 9)
Backup Mode 0 = Manual, 1 = Automatic non-Revertive, 2 = Automatic Revertive
<1> Backup 2 (Channel 9)
Force Manual
Modulator Backup Channel number for manual backup (1 to 8) (ignored if in automatic
mode or if channel 9 is configured as prime)
<1> Backup 2 (Channel 9)
Force Manual
Demodulator Backup Channel number for manual backup (1 to 8) (ignored if in automatic
mode or if channel 9 is configured as prime)
<4> Reserved (Reserved for RCS10, set to zero)
<4> Reserved (Reserved for RCS10, set to zero)
<1> Reserved (Reserved for RCS10, set to zero)
<1> Reserved (Reserved for RCS10, set to zero)
<1> Reserved (Reserved for RCS10, set to zero)
<1> Learned Modem 0 = Modem 0, 1 = Modem 1, 2 = Modem 2, 3 = Modem 3, 4 = Modem
4, 5 = Modem 5, 6 = Modem 6, 7 = Modem 7, 8 = Modem 8, 9 =
Modem 9, 10 = All Modems
<1> Test Modem
0 = Modem 1, 1 = Modem 2, 2 = Modem 3, 3 = Modem 4, 4 = Modem
5, 5 = Modem 6, 6 = Modem 7, 7 = Modem 8, 8 = Modem 9, 9 = All
Modems, , 10 = None
This byte should be forced to 10 if no tests are desired, failure to do so may result in
momentary loss of link on selected modem(s).
<1> Additional Bytes per
Channel 6 bytes as of release 4.0
<1> *Channel 0 Alarm 2
Mask Bit 0 = Mod learned
Bit 1 = Demod learned
Bit 2 = Mod configuration changed
Bit 3 = Demod configuration changed
Bits 4 through 7 = Spares
(0 =Mask, 1 = Allow)
<1> *Channel 0 Alarm 3
Mask Bits 0 and 1 = Mod Backup 1 Test Status Mask
Bits 2 and 3 = Demod Backup 1 Test Status Mask
Bits 4 and 5 = Mod Backup 2 Test Status Mask
Bits 6 and 7 = Demod Backup 2 Test Status Mask
(0 = Mask, 1 = Allow)