Basler Electric BE1-700 - Manual (Page 8)

Application Firmware
Version and Date Change
2.03.00, 07/09
• Increased immunity to noise when communicating via Modbus.
• Improved the SG-SCREEN command.
• Made firmware compatible with new digital board.
1.03.01, 10/08 • Improved Sync-check function.
• Increased immunity to noise on IRIG input.
• Improved web pages.
1.03.00, 11/07 • Added additional fault report screens to front panel HMI.
• Changed pickup setting range of 81 function.
• Changed default nominal frequency range.
• Added capability for the 25 function to synchronize down to 25 Hz.
1.02.02, 10/06 • Added style number and firmware version to fault reports and
sequence of events.
• Improved viewing of web pages using Firefox ®
browser.
1.02.01, 01/05
• Expanded LCD contrast adjustment.
• Improved 60FL function.
1.02.00, 08/04 • Added the Modbus/TCP option.
1.01.00, 07/04 • Initial release
Hardware
Revision and Date Change
S, 03/13 • Improved watts and vars metering.
R ,11/11 • Maintenance release.
Q • This revision letter not used.
P, 11/10 • Improved communications circuit on digital board.
N, 09/09
• Released BESTCOMS version 2.03.02 and firmware version 2.03.01.
M, 07/09
• Added power supply option 5, “125 Vac/dc with extended holdup”.
L, 06/09 • Standardized power supplies over several product lines.
K, 06/09 • Improved contact sensing circuit on digital board.
J, 09/08 • Released firmware version 1.03.01.
H, 09/08
• EEPROM replacement.
G, 01/08
• Added nylon washer on analog board to prevent hipotting.
F, 03/07 • Changed rear label for only Ethernet options.
E, 12/05 • Released new power supply boards.
D, 04/05 • Re-designed terminal block to make it more reliable.
• Modified Ethernet cutout on back of case.
C, 02/05 • Changed resistors on digital board to prevent input contacts on 24V
units from picking up too low.
B, 01/05 • Added Modbus/TCP/IP protocol option.
A, 07/04 • Added support for voltage relays (BE1-700V).
—, 06/04 • Initial release
vi BE1-700 Introduction 9376700990 Rev M