Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 51)

Hardware Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 51
When the IPMI_MODE_1 and IPMI_MODE_2 switches are OFF, the IPMI controller operates
normally. When both switches are ON, the IPMI controller enters programming mode. Any
other switch setting is not supported and treated as reserved.
When the IPMI_SYSEN switch is OFF, the IPMI operates in non-system mode. When the switch
is ON, IPMI operates in system mode.
When the FORCE_PM switch is OFF, the IPMI operates in non-peripheral management mode.
When the switch is ON, IPMI operates in peripheral management (PM) mode.
When the PMC2_PCI_FSEL switch is OFF, the maximum 100 MHz PCI bus frequency can be
used on PMC2. When the switch is ON, the maximum PCI bus frequency is 133 MHz. For more
information, see
PCI Bus Frequency on page 93 .
2.7 Installing the CPCI Baseboard
1. Attach an ESD strap to your wrist, and then attach the other end of the ESD strap to
the chassis as a ground.
The ESD strap must be secured to your wrist and to ground throughout the
procedure.
2. For a non-hot swap system, shut down the operating system.
3. Turn off the AC or DC power, and then remove the AC cord or DC power lines from
the system.
4. Remove the chassis or system cover(s) as necessary for access to the CompactPCI
modules.
Personal Injury or Death
This product operates with dangerous voltages that can cause injury or death.
Use extreme caution when handling, testing, and adjusting this equipment and its
components.