Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 161)

Control via IPMI
CPCI-6200 Installation and Use (6806800J66E) 161
The following table shows the firmware upgrade commands together with their network
function and command code.
7.3.1.1 Start Firmware Upgrade
The Start Firmware Upgrade command puts the target IPMC into firmware upgrade mode. The
command must be sent twice. Only the Firmware Upgrade commands and the Get Device ID
command are supported in firmware upgrade mode.
7.3.1.1.1 Request Data
No request data needs to be provided for this command.
7.3.1.1.2 Response Data
The following table lists the response data applicable to the Start Firmware Upgrade
command.
Table 7-10 Firmware Upgrade Commands
Command Name NetFn (Request/Response) CMD Description
Start Firmware Upgrade 0x08/0x09 0x1B See Start Firmware Upgrade
on page 161
Continue Firmware Upgrade 0x08/0x09 0x1C See Continue Firmware
Upgrade on page 162
Finish Firmware Upgrade 0x08/0x09 0x1E See Finish Firmware Upgrade
on page 162
Table 7-11 Response Data of Start Firmware Upgrade
Byte Data Field
1 Completion Code
0x00: Command executed successfully and target IPMC entered firmware upgrade
mode
0x01..0xFF: Error, that means IPMC cannot enter into firmware upgrade mode