Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 162)

Control via IPMI
CPCI-6200 Installation and Use (6806800J66E) 162
7.3.1.2 Continue Firmware Upgrade
The Continue Firmware Upgrade command writes a part of the firmware image to the target
IPMC. It also checks file integrity and makes the target IPMC leave the firmware upgrade mode
if an error occurs. If an error occurs, the whole firmware upgrade sequence must be repeated
beginning from the Start Firmware Upgrade command and the whole firmware upgrade
image must be retransmitted.
7.3.1.2.1 Request Data
The following table lists the request data applicable to the Continue Firmware Upgrade
command.
7.3.1.2.2 Response Data
The following table lists the response data of the Continue Firmware Upgrade command.
7.3.1.3 Finish Firmware Upgrade
The Finish Firmware Upgrade command makes the target IPMC leave the firmware upgrade
mode.
Table 7-12 Request Data of Continue Firmware Upgrade
Byte Data Field
1..23 Firmware content to be sent to the target IPMC.
The firmware image is a Motorola SREC file.
The whole message length is defined by the maximum IPMB message length.
Table 7-13 Response Data of Continue Firmware Upgrade
Byte Data Field
1 Completion Code
0x00: Command executed successfully
0x1..0xFF: Error, that means the IPMC left the firmware upgrade mode