Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 137)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 137
6. Slide the face plate (front bezel) of the PIM module into the front panel opening
from behind and pace the PIM module on top of the transition module, aligned
with the appropriate two PIM connectors (P0 and P4). The two connectors on the
underside of the PIM module should then connect smoothly with the
corresponding connectors on the transition module (J10 and J14). Refer to the
following figure for proper screw/board alignment.
7. Insert the four short Phillips screws, provided with the PIM, through the holes on
the bottom side of the transition module into the PIM front bezel and rear
standoffs. Tighten the screws.
8. With the CPCI-6115-MCPTM in the correct vertical position that matches the pin
positioning of the backplane, carefully slide the transition module into the
appropriate slot and seat tightly into the backplane.
Figure 5-9 Installing the PIM