Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 153)

MOTLoad Firmware
CPCI-6200 Installation and Use (6806800J66E) 153
vmeCfg Manages user specified VME configuration parameters
vpdDisplay VPD Display
vpdEdit VPD Edit
waitProbe Wait for I/O Probe to Complete
Table 6-1 MOTLoad Commands (continued)
Command Description
Note:
Due to the difference in endianness of the board, the sromWrite command automatically
swaps bytes as these are written into memory. The sromRead command accesses the actual
memory contents and does not swap bytes as it reads. Therefore, the memory that is read
through sromRead will look different from the source used by sromWrite.
For example, if the data being written start with this sequence:
15 16 1E 00 10 B5 65 40 00 CB 06 04 40 01 06 09
Then, the data retrieved through the sromRead command will appear as:
16 15 00 1E B5 10 40 65 CB 00 04 06 01 40 09 06
This behavior is normal for these commands on the CPCI-6200.