Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 210)

Memory Maps and Addresses
CPCI-6200 Installation and Use (6806800J66E) 210
8.4.18 Geographic Address Read Register
BP_RST_MASK CPCI Backplane Reset Mask
1 Disable backplane CPCI bus reset.
0 Enable backplane CPCI bus reset.
HS_LED_ON 1 Hot Swap (Blue) LED ON
1 Turn on Blue LED.
0 Don't turn on Blue LED.
SA_MODE Stand alone mode
1 Board operates in stand alone mode e.g.
operate in non-system slot and without
system slot board.
0 Board operates in normal mode.
SYS_EN_STS System Slot Operation Status
1 Board is operating in CPCI system slot.
0 Board is operating in CPCI peripheral slot.
1. The software cannot turn off the hot swap LED by writing this bit to 0 if the hardware has
turned on the LED. To turn it off, software must write 1 to mask bit above.
Table 8-38 CPCI Control/Status Register Field Definition (continued)
Table 8-39 Geographic Address Read Register, 0xF200_0019
Bit Field Operation Reset
7 GA4 R X
6 GA3 R X
5 GA2 R X
4 GA1 R X
3 GA0 R X
2 RSVD R 0