Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 46)

Hardware Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 46
The four connectors on the underside of the PMC module should then connect
smoothly with the corresponding connectors (J11/12/13/14) or (J21/22/23/24) on
CPCI-6200.
7. Insert the four short Phillips screws, provided with the PMC, through the holes on
the bottom side of CPCI-6200 and into the PMC front bezel and rear standoffs, and
then tighten the screws.
2.5.2 Installing the Rear Transition Module
For information on installing the rear transition module, see Chapter 5, Transition Module
Preparation and Installation .
2.6 Preparing the Baseboard for Installation
2.6.1 Inspecting the CPCI Baseboard
You can use the CPCI-6200 as a system controller in a system slot, an intelligent I/O board in a
peripheral slot, or in stand-alone mode.
The board is fully compliant to CompactPCI Hot Swap Specification PICMG 2.1 R2.0, and can
run in both 3.3 V and 5 V CompactPCI system.
Before installing the CPCI-6200, make sure that switches are configured as desired. For more
information, see
Hardware Configuration on page 47 .
 Install the accessory kits, before installing the board, if necessary.
 If memory modules have been installed, check that all socket locks of the board are
closed before board installation.