Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 111)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 111
5.5.1 IDE CompactFlash Connector
One 50-pin Type II CompactFlash card header connector located on both standard and MXP
versions of the CPCI-6115-MCPTM transition module provides the IDE interface to one
CompactFlash plug-in module. This CompactFlash interface is connected to the primary IDE
channel. The pin assignments for these connectors are as follows:
CompactFlash Selection Header (J2) CompactFlash Jumper on
page 123
Table 5-2 On-Board Connectors and Headers (continued)
Connector/Header Location
Table 5-3 CompactFlash IDE Connector Pin Assignments, J1
Pin J1 Pin
1 GND NO CONNECT 26
2 DD3 DD11 27
3 DD4 DD12 28
4 DD5 DD13 29
5 DD6 DD14 30
6 DD7 DD15 31
7 CS1FX1_L CS3FX1_L 32
8 GND NO CONNECT 33
9 GND DIOR_L 34
10 GND DIOW_L 35
11 GND +5 V 36
12 GND INTRQ1 37
13 +5 V +5 V 38
14 GND MASTER/SLAVE 39
15 GND NO CONNECT 40
16 GND DRESET_L 41
17 GND DIORDY 42