Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 121)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 121
5.5.6 COM1 And COM2 Connectors (MXP Version)
Four RJ-45 connectors are located on the panel of the MXP version of the CPCI-6115-MCPTM
to provide the interface to the COM1 and COM2 serial ports originating from the CPCI-6200
SBC. The CPCI-6200 only supports two serial ports, COM1 and COM2.
The COM1DIR jumper is a two position (three pin) jumper which controls the origin of the serial
port. In one position, COM1 from the CPCI-6200 is enabled (and thereby disabling it on the
CPCI-6200 front panel connector). In the other position, the connector is redirected to the
PMC I/O module 1. The COM2DIR jumper is a two position (three pin) jumper which controls
the origin of the serial port. In one position, COM2 from the CPCI-6200 is enabled. In the other
position, the connector is redirected to the PMC I/O module 2.
The pin assignments for this connector is as follows:
5.5.7 RJ-45 to DB-9 Adapter for COM1 to PC COM1
The following information is provided for those users wishing to attach a console to an CPCI-
6200 COM1 port for the purpose of terminal emulation.
A prewired, completely shielded RJ-45 to DB-9 female adapter assembly with 8 position RJ-45
socket on one end to DB-9 socket on the other end is available through Artesyn. This can be
ordered through Artesyn by requesting the following part number: MRJ45DB9ADP-01.
Table 5-10 COM1, COM2 Connector Pin Assignments
Pin Signal
1 DCD
2 RTS
3 GND
4 TXD
5 RXD
6 GND
7 CTS
8 DTR