Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 50)

Hardware Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 50
When the SA_MODE switch is OFF, board operation is normal. When the switch is ON, the
board operates in stand-alone mode i.e., it operates in a peripheral slot without the system
board in the chassis.
When the LRO_SW switch is OFF, if the board is placed in reset, it is only a local reset. When the
switch in ON, the board reset is propagated to CPCI bus. For more information, see
Reset
Control Logic on page 99 .
When the PWR12V_EN switch is OFF, the 12 V supply is enabled on the board and is available
for the RTM. When the switch is ON, the 12 V supply is disabled. Use the switch at ON position
when a 12 V supply is not available in the system or chassis.
2.6.3.2 IPMI Configuration Switch, S2
The CPCI-6200 uses an 8-position SMT configuration switch to control the IPMI controller
settings.
The default switch position is OFF.
When the IPMI_DISABLE switch is OFF, the IPMI device is enabled. When the switch ON, IPMI is
disabled by asserting its reset.
Table 2-4 S2 Switch Settings
Switch Name ON OFF (Default)
SW1 IPMI_DISABLE Keep the IPMI controller in reset
and thereby disable it IPMI controller is enabled
SW2 IPMI_MODE_2 JTAG Debug mode Normal operation
SW3 IPMI_MODE_1 Reserved Normal operation
SW4 - Reserved Reserved
SW5 IPMI_SYSEN Force IPMI in system mode IPMI operates in non-system
mode
SW6 FORCE_PM Force IPMI in PM mode IPMI operates in non-PM
mode
SW7 - Reserved Reserved
SW8 PMC2_PCI_FSEL Max PCI freq can be 133 MHz on
PMC2 Max PCI freq can be 100 MHz
on PMC2