Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 117)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 117
5.5.3 CompactPCI User I/O Connector
Connector J3 is a 95-pin AMP Z-pack 2mm hard metric type AB connector. This connector
routes the I/O signals for the PMC1 I/O, and two 10/100/1000Base-T ethernet ports. The pin
assignments for J3 on the processor board and on the CPCI-6115-MCPTM are as follows:
(Outer row F is assigned and used as ground pins but is not shown in the table).
Table 5-7 User I/O Connector Pinout, J3
Pin Row A Row B Row C Row D Row E Pin
19 GND +12 V -12 V GND GND 19
18 LPa_DA+ (TX1+)* LPa_DA-(TX1-)* GND LPa_DC+* LPa_DC-* 18
17 LPa_DB+ (RX1+)* LPa_DB-(RX1-)* GND LPa_DD+* LPa_DD-* 17
16 LPb_DA+ (TX2+)* LPb_DA-(TX1-)* GND LPb_DC+* LPb_DC-* 16
15 LPb_DB+(RX2+)* LPb_DB-(RX2-)* GND LPb_DD+* LPb_DD-* 15
14 +3.3 V +3.3 V +3.3 V +5 V +5 V 14
13 PMC1IO5 PMC1IO4 PMC1IO3 PMC1IO2 PMC1IO1 13
12 PMC1IO10 PMC1IO9 PMC1IO8 PMC1IO7 PMC1IO6 12
11 PMC1IO15 PMC1IO14 PMC1IO13 PMC1IO12 PMC1IO11 11
10 PMC1IO20 PMC1IO19 PMC1IO18 PMC1IO17 PMC1IO16 10
9 PMC1IO25 PMC1IO24 PMC1IO23 PMC1IO22 PMC1IO21 9
8 PMC1IO30 PMC1IO29 PMC1IO28 PMC1IO27 PMC1IO26 8
7 PMC1IO35 PMC1IO34 PMC1IO33 PMC1IO32 PMC1IO31 7
6 PMC1IO40 PMC1IO39 PMC1IO38 PMC1IO37 PMC1IO36 6
5 PMC1IO45 PMC1IO44 PMC1IO43 PMC1IO42 PMC1IO41 5
4 PMC1IO50 PMC1IO49 PMC1IO48 PMC1IO47 PMC1IO46 4
3 PMC1IO55 PMC1IO54 PMC1IO53 PMC1IO52 PMC1IO51 3
2 PMC1IO60 PMC1IO59 PMC1IO58 PMC1IO57 PMC1IO56 2
1 IPMI_PWR PMC1IO64 PMC1IO63 PMC1IO62 PMC1IO61 1