Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 122)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 122
Connecting an CPCI-6200 to a PC terminal requires that the adapter described above be
attached to a standard RJ-45-to-RJ-45 shielded cable with straight through signaling.
The pinout information for this adapter is in the following table:
5.6 Jumper Settings
This section describes the jumper settings that are required for proper operation prior to
installing the CPCI-6115-MCPTM transition module into a chassis backplane. Many boards are
already factory configured based on customer requirements, but the jumper settings should
be verified before installation.
Table 5-11 Wire Interconnection List RJ-45 to DB-9
RF-45 Signal RJ-45 Pin DB-9 Pin DB-9 Signal
DCD 1 4 DTR
RTS 2 8 CTS
GND 3 5 GND
TxD 4 2 RxD
RxD 5 3 TxD
GND 6 OPEN
CTS 7 7 RTS
DTR 8 6 DSR
Damage of the Product
Setting/resetting the switches during operation can cause damage of the product.
Check and change switch settings before you install the product.