Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 135)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 135
5.7.11 PMC I/O Module Presence Detection and Identification
Presence detection and identification of PMC I/O modules is currently an open issue. It is
anticipated that PMCs and PMC I/O modules will be designed as pairs. Any and all of the 64 bits
of PMC user I/O are available to the designers to use as they wish to detect and identify an
installed PMC I/O module. No standard exists, or is likely to exist, so hopefully the method
chosen will be sufficiently robust to prevent accidental misidentification of modules.
Host I/O modules also need to be detected and identified. To this end the I2C bus provided
from the CPCI-6200 SBC is connected to both PMC I/O module sites. The addresses and
content of the I2C devices to reside on the Host I/O module remain an open issue.
5.8 Installing the PIM
Procedure
If a PIM has already been installed on the CPCI-6115-MCPTM, or you are installing a transition
module as it has been shipped from the factory, disregard this section, and proceed to the
main installation section titled
Installing the Transition Module on page 138 . For PIM installation,
perform the following steps:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the
chassis as a ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove
the AC cord or DC power lines from the system.
3. Remove chassis or system cover(s) as necessary for access to the CompactPCI.
Product Damage
Inserting or removing modules in a non-hot-swap chassis with the power applied may result
in damage to the module components. The CPCI-6115-MCPTM is not a hot-swap board, but
it may be installed in a hot-swap chassis with power applied.
Remove the corresponding CPCI-6200 before the CPCI-6115-MCPTM is installed.