Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 138)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 138
9. Secure in place with the screws provided, making good contact with the transverse
mounting rails to minimize RF emissions.
10.Replace the chassis or system cover(s), reconnect the system to the AC or DC
power source, and turn the equipment power on, or if hot-swapping, you may now
install the CPCI-6200.
5.9 Installing the Transition Module
After all peripheral modules have been installed and all of the appropriate jumpers have been
set, you are ready to install the transition module in its chassis slot. At this point, follow the
steps below:
Procedure
To Install the rear transition module, follow these steps:
1. Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis
as a ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove
the AC cord or DC power lines from the system. Remove the chassis or system
cover(s) as necessary for access to the chassis backplane.
Personal Injury or Death
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing and adjusting.