Dell TL2000 - Manual (Page 65)

Using Factory Defaults as Your Configuration
The table below shows the main default library settings. If you wish to use the
defaults, no other changes need to be made before using your library
Item Default Setting
Logical Libraries 1
Active Slots Maximum
I/O Slots Enabled
DHCP Enabled
Internet Protocol IPv4 Only
Bar Code Label Length 8
Library Mode Random
AutoClean Disabled
Encryption Application Managed Encryption (AME)
For a full list of factory defaults, see “Configure: Restore Defaults” on page 5-24.
Configuring Your Library using the Web User Interface
To configure your library using the Web User Interface, complete the following
procedures:
1. “Entering Network Settings using the Operator Control Panel”
2. “Logging on to the Web User Interface” on page 4-17
3. “Verifying/Updating Firmware” on page 4-17
4. “Choosing General Library Settings” on page 4-18
5. “Choosing the Number of Logical Libraries for Your Library” on page 4-20
6. “Entering Path Failover Feature Activation Key” on page 4-21
7. “Setting Up Encryption” on page 4-21
8. “Choosing Drive(s) Interface Identification/Settings” on page 4-23
9. “Entering Library Network Settings” on page 4-24
10. “Entering User Access Information using the Web User Interface” on page
4-26
11. “Entering Date and Time using the Web User Interface” on page 4-26
12. “Configuring Logs and Traces using the Web User Interface” on page 4-27
13. “Entering Event Notification Information using the Web User Interface” on
page 4-27
14. “Running Key Path Diagnostic for Testing Encryption Configuration” on page
4-28
15. “Restoring Factory Default Settings using the Web User Interface” on page
4-28
16. “Logging out of the Web User Interface” on page 2-7
17. “Setting the Operator Control Panel Access PIN using the Operator Control
Panel” on page 4-29
Entering Network Settings using the Operator Control Panel
Static library network settings must be entered using the Operator Control Panel
before the library can be accessed remotely using the Web User Interface. If your
Chapter 4. Installation and Configuration 4-15