Dell TL2000 - Manual (Page 192)

Important: Push in on the drive sled handle ( 10 in Figure 10-5 on page
10-4) while supporting the bottom of the drive sled until it is
properly seated. Damage to the connector pins may occur if this
procedure is not followed.
10. Push the drive sled slowly into the drive slot until the sled seats itself against
the back of the library.
11. Tighten the captive thumbscrews ( 7 in Figure 10-5 on page 10-4) until the
drive sled is secure.
12. If you are installing a drive sled without ESD springs (see Figure 10-3 on
page 10-3), apply conductive tape to the sled as shown in Figure 10-8 on page
10-7.
a77ug028
Figure 10-7. Pushing the drive sled into the library (drive sled without ESD springs shown)
10-6 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide