Dell TL2000 User Manual

Page 167

background image

1.

Navigate

to

Move

Cartridges

using

the

Operator

Control

Panel

(Control

→

Move

Cartridges

).

2.

Select

Source

.

3.

Scroll

through

the

different

slots

containing

cartridges,

and

look

for

an

exclamation

point

(!).

The

exclamation

point

indicates

that

the

cartridge

is

bad

or

was

rejected

due

to

wrong

format,

write

protected,

etc..

4.

Select

the

marked

cartridge

as

the

Source

and

the

I/O

Station

as

the

Destination

(Dest.).

5.

Select

Move

.

6.

Open

the

I/O

Station

(Control

→

I/O

Station

).

7.

Remove

the

marked

cartridge

from

the

I/O

Station

and

dispose

of

properly.

8.

Close

the

I/O

Station.

If

the

amber

LED

was

lit

because

of

bad

media,

the

Attention

LED

will

turn

OFF.

If

the

amber

LED

is

still

on,

check

the

power

supply

or

the

power

supply

fans.

See

Chapter

7.

Troubleshooting

7-13