Pitney Bowes MapMarker USA - Manual (Page 66)

Opening a Table or Text File
MapMarker USA 25
66
User Guide
L
You can open only one project at a time.
After opening the project you can geocode using the column mappings and geocoding preferences
that were saved with the project. Or you can you make changes before proceeding with geocoding.
If you are using an old project, you may get an initialization error when you try to run the project in
MapMarker USA 25. This is because your project is pointing to an older Address Dictionary. You can
ignore this error message, and the project will then use the MapMarker USA 25 Address Dictionary.
To eliminate this error message, see the
Note on page 108 with Creating and Saving a Project .
Running a Project from a Batch File
You can run a project from a command line batch file. For this syntax see Creating a Project-Based
Batch File on page 109 .
Opening a Table or Text File
The following steps describe how to select and open your input file. See Supported File Formats
on page 54 .
L
This procedure applies to opening local files. For instructions on opening remote tables, see
Geocoding Remote Tables .
1. Start MapMarker from the Windows Start menu or Shortcut menu.
2. Select File > Open Table, click or click the right mouse button to display a shortcut menu.
The Open Table dialog appears. Select the folder that contains your tables and click Open.