Pitney Bowes MapMarker USA - Manual (Page 42)

Upgrading the MapMarker Installation
MapMarker USA 25
42
User Guide
If you want to add or remove features or change settings, you must first upgrade and then run the
installer again to modify your installation (see
Modifying the MapMarker Installation on page 40 ).
Alternatively, you may uninstall and then re-install MapMarker if you have changes that cannot be
done using the Modify option.
L
You cannot upgrade from one major release to another. For example, you cannot upgrade
from MapMarker 24 to Version 25. You must do a new installation of MapMarker 25. You can
then upgrade from version 25 to a 25.x point release, when that becomes available.
You can have different major releases on the same workstation (such as MapMarker USA
Version 24 and Version 25), but you cannot have different point releases installed on the same
workstation (For example, version 25.0 and version 25.1 cannot be on the same workstation.)
Upgrade Using the Graphical Interface on page 42
Upgrade Silently on page 43
Upgrade Using the Graphical Interface
To upgrade from MapMarker USA v25 to a point software release, do the following:
1. Start the installer as described in step 1 of Install Using the Graphical Interface on page 33 .
2. In the Introduction dialog, click Next to display the What’s New dialog.
3. In the What’s New dialog, click Next to display the Licensing Agreement dialog.
4. After reading the License Agreement, click I accept the terms of the License Agreement and
then click Next to display the Choose Upgrade Type dialog.
5. The Choose Upgrade Type dialog presents the opportunity to upgrade data only, or software
plus data. For example: