KEYENCE KV Series - Manual (Page 82)

Chapter 2 Editor
2-58
2
2.7 Jump, Search, and Replace
This section describes how to jump to any position in a ladder diagram, search for
an instruction word/operand, and replace operands or N.O./N.C. contacts.
2.7.1 Jump
The edit control can jump to any position by specifying the desired line number or
step number of the program. The edit control can also be jumped to the first or last
line. Use the jump function to quickly change the edit position.
Jump to the specified line/step
Edit ➔ Jump ➔ Line/Step No.
To jump to another position by specifying the desired line number or step number of
the ladder program, perform the following procedure.
1. Select "Edit", "Jump," and "Line/Step No." from the menu. You can also enter the
desired line number or step number directly from the keyboard.
The "Jump to Specified Line" dialog box is displayed.
2. Specify the line number or step number as the jump destination.
When a line number or step number is entered from the keyboard in step 1, it is
already specified.
3. Click the [Line] button when jumping the edit control by specifying a line number.
Click the [Step] button when jumping the edit control by specifying a step num-
ber.
Click the [Cancel] button to cancel jumping.
The specified line or step is displayed, and the cursor is moved to the specified
line or step.
Note: When a number larger than the last line or step number is selected, the last
line or step is displayed.
KVSKA Chap 02.P65 08.3.11, 11:28 AM 58