KEYENCE KV Series - Manual (Page 142)

Chapter 3 Simulator
2-118
3
Changing the current value/preset value/attribute
The dialog bar is a tool shared by the ladder monitor window, the monitor all window
and the registration monitor window, and allows you to register new devices and
change the setting of the selected device.
The following items can be set using the dialog bar.
• Device type
• Device No.
• Bit count
• Radix
• Comment display method
• Current value
• Preset value (only in a timer/counter)
■ Setting procedure
1 Select the monitor window for which devices are to be changed as the current
window. Place the cursor over the device to be changed, and click it.
2 Change the current value, preset value and attribute using the dialog bar.
➮ For items, contents and precautions on changing settings, refer to "Changing the current value/
preset value/attribute" on page 2-96.
3 Click the [Write Current Value] or [Write Preset Value] button.
• The contents set using the dialog bar are written to the selected device.
■ To cancel the setting entered
Click the [Cancel] button.
■ To return the setting of a timer/counter to the default value.
Click the [Reset] button. (This button is displayed only when a timer/counter is set.)
Note: Even if bit devices are turned on/off or the current/preset values are changed
while operation is stopped, these settings are reset when an operation is started up.
Pause the operation, and then change the device status.
Resetting devices
Edit ➔ Reset Device in Monitor All/Registration Monitor
To reset the selected device to the default value, perform the following procedure.
Select "Reset Device in Monitor All/Registration Monitor" from the "Edit" menu.
• The current value of the selected device is returned to the default value.
Comment Preset value write button
Radix Current value write button
Preset value write box Current value write box
KVSKA Chap 03.P65 08.3.11, 11:29 AM 118