KEYENCE KV Series - Manual (Page 218)

Appendices
2-194
Appendices
● Operations in the ladder monitor
Move between panes [F5]
Move cursor [LEFT]•[RIGHT]•[DOWN]•[UP]
Move cursor by unit of block [Ctrl] + [DOWN]•[UP]
Move cursor to the beginning of line [Home]
Move cursor to the end of line [End]
Reverse bit devices [ ]
Read values to dialog bar [ENTER]
Switch numbering system (decimal ÷ hexadecimal) [Ctrl]+[E]
● Operations in the registration monitor
Move cursor [DOWN]•[UP]
Move vertical cursor on timing chart [LEFT]•[RIGHT]
Changes over selection of vertical cursor [Tab]
on timing chart
Reverse bit devices [ ]
Reads values to dialog bar [ENTER]
Delete devices [Delete]
● Operations in the monitor all
Move cursor [DOWN]•[UP]
Move bit cursor [LEFT]•[RIGHT]
(only for binary 16-bit bit devices)
Reverse bit devices [ ]
Reads values to dialog bar [ENTER]
● Operations on the mnemonic window
Move cursor [DOWN]•[UP]
Sets/cancels break point [ ]
● Operations on the break condition window
Move cursor [DOWN]•[UP]
Change/register break condition [ENTER]
Delete break condition [Delete]
● Other operations common to all the windows
Close window [Ctrl] + [F4]
Move between windows [Ctrl] + [F6]
Move between windows (reverse direction) [Ctrl] + [Shift] + [F6]
KVSKA Appendix.P65 08.3.11, 11:26 AM 194