KEYENCE KV Series - Manual (Page 27)

Chapter 1 Introduction
2-3
1 1
1.2 Outline of the Ladder Builder for KV
This section describes the operation environments, system configuration, features,
functions, etc. of the Ladder Builder for KV. Be sure to read this section before using
the Ladder Builder for KV.
1.2.1 Operating environment and system configuration
The following operating environment is required to run the Ladder Builder for KV.
Ensure that your system satisfies the following conditions and that the required
equipment is provided.
■ Personal computers supported
Models supporting Windows 3.1 or later (equipped with the RS-232C interface)
IBM PC and PC/AT or compatible machine
■ CPU memory capacity
i486DX2 or higher (Pentium 90 MHz or higher is recommended.)
8 MB RAM (16 MB or more is recommended.)
■ Compatible operating systems
• Windows 3.1
• Windows 95
■ Font types required (Make sure to install them.)
• MS Sans Serif
• Small fonts
• Arial
Each of them is supplied as standard in Windows 95.
■ Free space on hard disk
4.5 MB or more
■ KV and each unit
Connect the required units such as KV to the personal computer to use the
monitor functions and transfer programs using the Ladder Builder for KV.
➮ Refer to “1.3 Before Programming” on page 2-7.
Note: The Ladder Builder for KV does not support long file names.
Printer that can be connected
to the personal computer and
supports Windows (300 dpi or
higher)
Printer
Display
Resolution: 640 x 480 or higher
KV Series PLC
KVSKA Chap 01.P65 08.3.11, 11:27 AM 3