KEYENCE KV Series - Manual (Page 221)

Appendices
2-197
1
Appendices
Setting the number of scales for timing charts
Settings ➔ Set No. of Scales for Timing Chart 2-129
Allows you to set the number of scales to be displayed on timing
charts.
Copying and deleting the device attribute
Edit ➔ Copy Device Attribute in Registration Monitor 2-125
➔ Delete Device in Registration Monitor 2-127
Copies the attribute (bit count, radix and comment type) set in the
currently selected device to another device, or deletes the device.
Sorting devices Edit ➔ Sort Devices in Registration Monitor 2-127
Sorts (arranges) devices in order.
Timing chart 2-128
Timing charts for the registered devices are displayed while scans or
steps are executed (only when "Comment" on the dialog bar is set
to "No").
Changing the current value/preset value/attribute (dialog bar)
Change device types, device numbers, current values, preset values, 2-96
etc. using the dialog bar, or register new devices to each monitor.
Set the bit count, radix and comment display method.
Changing the current values all at once
Changing the current values all at once File ➔ Change All 2-150
Reads devices in the specified range from the PLC, changes the
current values on an on-line basis, and then writes the changed
current values to the PLC.
Changing the mode
Editor File ➔ Editor 2-142
Terminates communication with the PLC, and changes to editor mode.
Printout
Printing out the registration monitor File ➔ Print 2-132
Prints out the contents currently displayed on the registration monitor.
KVSKA Appendix.P65 08.3.11, 11:26 AM 197