KEYENCE KV Series - Manual (Page 207)

Appendices
2-183
1
Appendices
Communicating with PLC
Setting PLC communication parameters
File ➔ Communication Setup ➔ Set PLC Communication Parameters 2-136
Sets parameters required for communication with the PLC.
Transferring, reading, and verifying programs
File ➔ Monitor ➔ Compile ➔ Transfer ➔ Monitor 2-139
➔ Read Program from PLC 2-141
➔ Verify against PLC Program
Transfers compiled ladder programs to the PLC, and switches to
monitor mode. Reads programs transferred from the PLC. Verifies a
program in the PLC against a program on the editor.
Editing devices while offline
File ➔ Monitor ➔ Edit Offline Device 2-142
Edits devices in the PLC while off-line in monitor mode.
Changing the mode
Monitor
File ➔ Monitor ➔ PLC Monitor 2-139
➔ Compile ➔ Transfer ➔ Monitor
Changes to the monitor. Note that the monitor cannot be started up if
compilation errors are present.
Simulator File ➔ Simulator 2-86
Changes to the simulator. If the ladder program is not yet compiled, it
is compiled when the simulator is started up.
Changing the display mode
Setting the display mode and the change range
View ➔ Display Mode 2-19
➔ Zoom In
➔ Zoom Out
➔ Show Label
➔ Show Comment
Sets the display size and display status of labels/comments.
Sets the range in which the display mode setting is valid.
2-21
Changing colors in ladder diagrams
Changing colors in ladder diagrams
View ➔ Change Ladder Diagram Color 2-82
Sets the color layout of ladder diagrams.
Setting/changing the model
Setting and changing the model File ➔ Change Models 2-17
Sets/changes the model of the connected PLC.
Printout
Printout and print preview File ➔ Print 2-132
➔ Print Preview 2-131
Prints out ladder diagrams, mnemonic lists, labels/comments/
references and the device usage status. The printout range can be
specified precisely.
Exiting from a program
Exiting from a program File ➔ Exit
Exits from a program.
KVSKA Appendix.P65 08.3.11, 11:26 AM 183