KEYENCE KV Series - Manual (Page 61)

Chapter 2 Editor
2-37
1 2
2.4 Entering/Deleting Symbols and Connection Lines
This section describes how to enter/delete symbols and connection lines to/from a
ladder diagram.
2.4.1 Entering symbols
A ladder symbol is automatically entered when an instruction word is specified.
An instruction word can be entered using either of the following two methods.
In the first method, you can select the desired instruction word type and the desired
instruction word code from the "Enter Instruction Word" window. In the second
method, you can directly enter the desired instruction word from the dialog box
displayed when the first character of the desired instruction word is entered.
Or you can enter an a (N.O.) contact, a b (N.C.) contact, an a (N.O.) contact OR, a b
(N.C.) contact OR, or a coil in the current cursor position.
➮ 2.4.3 Entering contacts/coils directly (p. 2-42)
• Selective input
• Direct input ➮ p. 2-41
KVSKA Chap 02.P65 08.3.11, 11:28 AM 37