Doepfer A-100(~ 40 MB) - Manual (Page 733)

doepfer System A - 100 Trautonium / Ribbon Controller A-198
5
4. In- / Outputs
! CV
The position dependent Control Voltage CV
POS
is
available at this output.
" Gate
The position dependent Gate signal Gate
POS
is avai-
lable at this output (active only in the Off position of the
Hold switch).
§ CV
The pressure dependent Control Voltage CV
PRES
is
available at this output.
$ Gate
The pressure dependent Gate signal Gate
PRES
is
available at this output. Whenever the pressure con-
trol voltage exceeds the threshold adjusted with con-
trol 4 the Gate output $ turns to high.
% Contr. Board
The position and pressure sensors are located in a
separate metal frame. The connection between the
module and the sensor frame is made by a 4 pin cable
(same connectors and cable as used for USB connec-
tions). Socket % is used for the junction cable to the
sensors. The junction cable and the metal frame that
contains the sensors is included with A-198 manual.
A It is not allowed to connect any USB
device to socket %
% % % ! The USB device
connected to the socket and the A-
198 module will be destroyed and the
warranty for both devices is void !