Doepfer A-100(~ 40 MB) - Manual (Page 662)

A-190 MIDI-CV/SYNC Interface System A - 100 doepfer
8
4.2 CONFIG menus
CHANNEL / REF. NOTE
The CHANNEL parameter sets the MIDI receive
channel. In performance mode, MIDI messages re-
ceived on this channel are converted to CV and gate
signals and sent to whichever modules are connected
to the A-190 - either via the system bus or via patch
leads.
REF. NOTE sets the bottom note on the MIDI key-
board which will play the lowest note on the A-100
VCOs. As a rule, this is MIDI note number 36.
M M M M
NOTE ON ch n vel
ch : MIDI channel
n : MIDI note number
H Note that playing a note on the key-
board will set MIDI channel and bot-
tom note at the same time.
This method of setting the MIDI chan-
nel is preferable to the performance
mode method, which has no confirma-
tion.
[m m m m
Change the bottom MIDI note (0 to 127)
]
GATE POLARITY
This parameter sets the polarity of the gate voltage.
H For use with the A-100, this parameter
should always be set to positive. The only
time you may need to alter it is to control
certain other makes of synthesizer.
M M M M positive: PROG CHANGE 1
negative: PROG CHANGE 2
Config Menu 1
CV 1
0
+12 V ....
0 V ..
+12 V .
0 V ...