Doepfer A-100(~ 40 MB) - Manual (Page 330)

A-129 /3/4 Modular Vocoder System A - 100 doepfer
6
4. In- / Outputs
! CV In 1 ... CV In 5
Sockets ! are CV inputs. This is where you patch in
the voltages you would like to modify - ie, attenuate,
offset, or smooth out by slew limiting.
" CV Out 1 ... CV Out 5
Sockets " are CV outputs, at which the modified
signals are available.
Each output signal is affected by a combination of
the attenuator, offset and slew limiter functions.
§ Slew Control Input
Socket § is the input for the CV generated by the
A-129 /4 Slew Limiter Controller.
This input should be connected with output & on the
A-129 /4.
This is a specialised control signal which must
come from the A-129 /4. Connecting signals from
other modules won’t make sense.
$ Freeze Control Input
A gate signal at input $ freezes the slew limiter’s
output signal (see Fig. 3).
H This function is only active when the switch
3
is in the ‘slew’ position.
Fig. 3: Using a gate signal to freeze a voltage
CV
Out
CV
In
Freeze
Contr.
In